ADLINK aTCA-9700 - Manual (Page 61)

61
6.3.9
COM1 Console Redirection
This item is used to configure the enabling/disabling of console redirection to each
COM port. For example, COM1 is set to enable console redirection. The below
screen will be needed to set properly for communicating with other computer that is
using terminal software to receive the message from aTCA-9700.
Terminal Type
VT-UTF8 is the preferred terminal type for out-of-band management. The next best
choice is VT100+ and then VT100.
Bits per second
Select the bits per second that you want serial port to use for console redirection.
Data Bits
This option allows to select the data bits you want the serial port to use for console
redirection.
Parity
Set this option to select Parity for console redirection.
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the beginning).
The standard setting is 1 stop bit. Communication with slow devices may requires
more than 1 stop bit.