6 switch and jumper settings, Switch and jumper settings, 1 set blade operation mode – ADLINK aTCA-9700 User Manual
Page 24: 2 ipmc jtag signal, 3 shelf/logic ground jumper

24
3.3.6
Switch And Jumper Settings
3.3.6.1
Set Blade Operation Mode
Use switch SW4 to set the Blade Operation Mode. Normal operation requires a shelf
manager for the blade to boot. Standalone mode allows the blade to boot without a shelf
manager.
SW4 Blade Operation
Pin 1
Pin 2
Pin 3
Pin 4
Normal Mode (default)
OFF
OFF
OFF
OFF
Standalone
Mode
OFF OFF ON OFF
3.3.6.2
IPMC JTAG Signal
The switch SW12 is designed for hardware debug purposes. Do not change the default
settings. Doing may result in an abnormal boot, failure to boot, and or damage to the board.
SW12 IPMC JTAG
Pin 1
Pin 2
Pin 3
Pin 4
Default Setting
OFF
ON
ON
ON
3.3.6.3
Shelf/Logic Ground Jumper
Use JP2 to short Shelf Ground to Logic Ground.
Shelf/Logic GND
JP2 Setting
Shorted 1-2
Open (default)
2-3
The locations of SW4, SW12 and JP2 are shown below:
SW4
JP2
SW12
- USB-1901 (84 pages)
- USB-1210 (54 pages)
- USB-2401 (60 pages)
- USB-7230 (50 pages)
- USB-2405 (56 pages)
- DAQe-2010 (92 pages)
- DAQe-2204 (100 pages)
- DAQe-2213 (94 pages)
- DAQe-2501 (74 pages)
- PXI-2010 (84 pages)
- PXI-2020 (60 pages)
- PXI-2501 (62 pages)
- cPCI-9116 (98 pages)
- ACL-8112 Series (93 pages)
- ACL-8112 Series (94 pages)
- ACL-8112 Series (92 pages)
- ACL-8216 (75 pages)
- ACL-8111 (61 pages)
- PCM-9112+ (10 pages)
- PCM-9112+ (94 pages)
- cPCI-6216V (47 pages)
- ACL-6126 (28 pages)
- ACL-6128A (40 pages)
- PCM-6308V+ (52 pages)
- PCM-6308V+ (4 pages)
- PCI-7444 (82 pages)
- PCI-7434 (48 pages)
- PCI-7234 (56 pages)
- PCI-7260 (66 pages)
- PCI-7258 (38 pages)
- PCI-7256 (48 pages)
- PCI-7250 (48 pages)
- LPCI-7250 (48 pages)
- PCI-7396 (65 pages)
- PCI-7296 (59 pages)
- PCI-8554 (67 pages)
- PCIe-7360 (94 pages)
- PCIe-7350 (86 pages)
- PCIe-7300A (114 pages)
- PCIe-7200 (51 pages)
- PCI-7300A (112 pages)
- PCI-7300A (83 pages)
- PCI-7200 (96 pages)
- cPCI-7300 (82 pages)
- cPCI-7300 (83 pages)