D-Link DI-724GU - Manual (Page 32)

32 D-Link DI-724GU User Manual
Section 3 - Configuration
PPPoE
Select this option if your ISP requires you to
use a PPPoE (Point to Point Protocol over
Ethernet) connection. DSL providers typically
use this option. This method of connection
requires you to enter a Username and
Password (provided by your Internet Service
Provider) to gain access to the Internet.
Note: When using the PPPoE option, you will
need to ensure that any PPPoE client software
on your computers is removed or disabled.
If your ISP has assigned a fixed IP address,
select Static IP and enter the fixed IP address
in the following field. For PPTP and L2TP,
the subnet mask and the default gateway IP
address must also be entered. If the ISP’s
servers assign these values upon establishing
a connection, select Dynamic IP.
When required, this value is provided by the
ISP.
This value is provided by agreement between
you and the ISP.
This value is provided by agreement between
you and the ISP.
Re-enter the password.
Service Name is optional, but may be required
by some ISPs. If your ISP provides a Service
Name, enter the provided value here.
PPPoE:
Dynamic IP/Static IP:
IP Address:
Username:
Password:
Verify Password:
Service Name: