Acrosser AR-B1894 - Manual (Page 39)

4.2.5.3 Run VGABIOS if S3 Resume
This item is to select whether to run VGABIOS if resumed from S3 state but for
older VGA drivers only. Please select Auto (Default) if in doubt.
4.2.5.4 Power
Management
There are three selections for power management and HDD power down. The
Min. Power Saving sets the HDD Power Down at 15 Min., Max. Power Saving at
1 Min., and User defined from 1 Min. to 15 Min. and disabled but from 1 Min. to 1
hour while disabled.
4.2.5.5 Video Off Method
Determines the manner in which the monitor is blanked. V/H SYNC + Blank turns
off vertical and horizontal synchronization ports and writes blanks to the video
buffer; DPMS Support is for the monitor supports the Display Power
Management Signaling(DPMS) standard of the Video Electronics Standards
Association(VESA); Blank Screen set the system only writes blanks to the video
buffer.
4.2.5.6 Video Off In Suspend
This item allows to set if the monitor is blanked in Suspend mode. The default
setting is Yes.
4.2.5.7 Suspend
Type
This item will set the system status to shut down the PC with choices of Stop
Grant and PwrOn Suspend.
4.2.5.8 MODEM Use IRQ
This determines the IRQ in which the MODEM can use.
4.2.5.9 Sort-Off by PWR-BTTN
Pressing the power button for more than 4 seconds/Instant-Off forces the system
to enter the Soft-Off state when the system has “hung”.(Only could working on
ATX Power supply).
4.2.5.10 Wake-Up by PCI Card
This will enable the system to wake up through PCI Card peripheral or not.
4.2.5.11 Power On by Ring
The function allows the system boot up if there’s an incoming call from the
modem.
4.2.5.12 USB KB Wake-Up From S3
This option is used to enabled/disabled USB keyboard wake up with suspend to
RAM.
4.2.5.13 Primary/Secondary IDE 0/1
This function is for setting IDE 0/1 on primary/secondary mode.
4.2.5.14 FDD,COM,LPT Port
System can be awaked by Floppy Drive, COM or LPT port.
4.2.5.15 PCI PIRQ[A-D]#
This function will cause the system waking up completely from the power
management mode.