beautypg.com

D-Link DSL-1500G User Manual

Page 22

background image

DSL-1500G SHDSL Ethernet Router User’s Guide

12

2. The remaining settings that must be configured are different for the different Connection Profile types.

• If you have a Router with PPoA or Router with PPoE Connection Profile, you must supply a

User Name and Password used to verify the identity of your account. Type in the User Name
and Password used for your PPP connection. Also select the Authentication method used, pap
or chap, choose Enabled for Connect On Demand and leave the Idle Time setting at 0.

• If you select Bridge with RFC 1483, there are no more changes needed to establish the WAN

connection for the Router. However, you may have to install some sort of connection software
on your computer. Follow the instructions given to you by your ISP or network service
provider.

3. Click

the

OK button when you have entered all the information. A new prompt dialog box appears

4. Click

the

OK button. The Router will save the configuration settings and restart. After restarting it will

begin to negotiate the connection. You can login to the web manager again.

• If you are using a PPPoA or PPPoE Connection Profile you will see the same Router/Bridge

Configuration menu, check the Router’s Connection Status at the bottom of the web page.
The Connection Status should indicate the Router is Connecting. When this indicates the
Router is Connected you can access the Internet or continue to configure the Router.

• If you are using a Bridge with RFC 1483 Connection Profile a different menu will appear after

you login (see example below).

Router/Bridge Configuration (Bridge with RFC 1483 only)

NOTICE: If you change the Connection Profile, click the OK button without
making any other changes. Save the changes and reboot the device.
Upon restarting continue to configure any remaining settings that need to
be changed in the Router/Bridge Configuration Menu as instructed in the
remaining steps below. It will again be necessary to save settings and
restart the Router to establish the WAN connection.