Dakota Digital MCL-2002 - Manual (Page 3)

MAN# 650280:D
•
Remove the dash
•
Unclip and unplug the factory gauge
•
Insure that the rubber gasket is still in the dash or
remove from factory gauge and place back on
dash
•
Insert new gauge from front of dash
•
Use supplied L-brackets along with the 8-32 screws
and lock washers to secure the gauge
•
Reinstall the dash
Deuce mounting
NOTE: The supplied L-bracket mounting pieces are not used for this application and can be discarded
Since the Deuce gauge mounts from under the dash mounting requires use of the supplied ABS bracket.
Factory Dash
Panel
Factory Bezel
Gasket
Dakota Digital Gauge
MCL-2002 (-R)
New ABS Mounting Bracket
(supplied)
#8 Lock Washer
8-32 x ½” Screw
Mounting Tabs (cast in
dash)