American Standard 2506.011 - Manual (Page 4)

10
TEST INSTALLED FITTING
With HANDLE (1) in OFF position, turn on WATER
SUPPLIES
[2) and check all connections for leaks. ^
Remove AERATOR (3).
Operate HANDLE (TJ to flush water lines thoroughly.
Replace AERATOR (3).
CHECK DRAIN CDNNECT1DNS
Operate POP-UP KNOB (4) and fill Bidet with water.
Check that DRAIN STOPPER (5) makes a good seal
and retains water in Bidet. If DRAIN STOPPER (5)
does not seal properly please refer to Troubleshooting
section in these instructions.
Release POP-UP KNOB (4) down and check all drain
connections and "P" trap for leaks.^ Tighten
if necessary.
11
SERVICE CAUTION
Turn off hot and cold water
supplies before beginning.
Turn on valve and allow water supply temperatures to
stabilize. Move HANDLE to full HOT setting. Check
water temperature.
1
-
To decrease hot limit temperature setting:
■ Pull out Plug Button (1), loosen Handle Set Screw (2)
and remove Handle [3) from Cartridge Stem [5). Remove
Cartridge Cover (4).
■ Lift Setting Insert (6), rotate counterclockwise one notch
and replace. Check water temperature and repeat if
necessary. Unit is factory set at "0" [full HOT water]. As
the setting number increases, the more cold water is
supplied in the full HOT handle position.
■ Replace Cartridge Cover I4J. Align Handle I3) and tighten
Set Screw (2). Replace Plug Button m
CARTRIDGE
HOTTEST
Blend control
setting 0 - setting
insert covers blend
control setting
number 1-4
COOLEST
Blend control
setting 4
TOP
TOP
12
EverClean™ Finish Care Instructions
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean
water may also be used, if desired. IMo additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
M968936