American Standard 2506.011 - Manual

AhtM'eaiii Shmia/rd
MOMENTS
Monoblock Bidet Faucet with
EverClean™ Finish & Speed Connect™ Drain
Installation
Instructions
2506.011
Certified to comply with ANSI A112.18.1
M968936
Congratuiations on purchasing your American Standard faucet with the
EverCiean finish and Speed Connect drain, two features found only
on American Standard faucets.
EverClean Finish
• One wipe effortlessly removes spots.
• Eliminates the need for cleaners and scrubbing.
• Permanent surface protectant remains beautiful
for the life of the faucet.
• EverClean™ available on: Polished Chrome, Satin Nickel,
Stainless Steel, Polished Brass (or any combination of these finishes)
*Your new American Standard faucet is designed to work only with the Speed Connect drain.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin
Speed Connect Drain*
• Fewer parts, installs in less time.
• Never needs adjustment.
• Guaranteed to seal properly the first time, every time,
Recommended tools
Screwdriver Chennel Locks Adjustable Wrench
INSTALL FAUCET CAUTION
'Hirn off hot and cold water
supplies before beginning.
Seat SEAL (1J into under side of FAUCET BASE [2).
Feed FAUCET SUPPLIES (3). MOUNTING STUD (4) and DRAIN
CABLE ASSEMBLY ( 8 ) through the mounting hole of lavatory or
mounting surface. Fig. A
From below, Dush GASKET 17) and RETAINING WASHER (5) onto
MOUNTING STUD (4). Secure Faucet with MOUNTING NUT (6),
pulling faucet to front of sink, so SUPPLIES (3) rests against
mounting hole. Before final tightening, make sure collar on
MOUNTfNG NUT
(6) is seated into STAINING WASHER (5).
Fig. B.
Adjust Faucet so that it is centered. Tighten MOUNTING NUT ( 6 )
to complete faucet mounting.
Fig. A
GROOVE
(FAUCET
BASE)
Fig. B
MOUNTING SURFACE
COLLAR ON
MOUNTING NUT