Connections, 2 connect the speaker cords to the speakers – Aiwa XR-M88 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PREPARATIONS
CONNECTIONS
Before connecting the AC cord
The rated voltage of your system shown on the bottom of the
tuner/amplifier unit is 120 V AC. Check that the rated voltage
matches your local voltage.
IMPORTANT
• Connect the speakers, antennas, and all optional equipment
first. Then connect the AC cord.
• There are no differences between the front speakers. Both
speakers can be connected as L (Left) or R (Right).
1 Place the CD/tape unit on top of the tuner/
amplifier unit and plug in the connector of the
flat cable as shown below.
Note that the connector can be plugged in in only one direction
with the flat cable facing left.
2 Connect the speaker cords to the speakers.
Connect the cords with the white stripes to © terminals and
the other cords to © terminals.
3 Connect the speaker cords to the tuner/amplifier
unit.
The cords with the white stripes should be connected to the
O terminals and the other cords to the © terminals.
After plugging in the connector, aiiow adequate ciearance
between the fiat cabie and the ventiiation openings.
FM antenna
4
ENGLISH