Aiphone MY-CA - Manual (Page 2)

MOUNTING
Back frame
Single-gang
box
83.5 mm
(3-5/16”)
Plug off power supply prior to wiring on any unit.
MY-CA surface-mounts on wall with 83.5mm, 3-5/16” guide,
or on single-gang box.
1. Remove screw cover, pulling from bottom notch,
2. Loosen a tamper-proof screw with supplied driver.
3. Mount back frame at 2 points.
4. Secureiy connect non-polarized A1, A2 terminals with 2
wires with sufficient insulation.
5. Remount MY-CA on back frame.
★ Do not apply any sealant around MY-CA, as openings are
provided for ventilation.
5
WIRING
i
OPERATIONS
Wiring distance: WIY-CAto Video-monitor MY-1CD ,etc. The red LED is lit to locate call button, day
or night. A single push of Call button
activates inside video monitor, as well as a 4
or 2-tone chime (or other). When inside
station replies, talk handsfree.
★ Poor lighting conditions:
The MY-CA infrared illumination will light
the image of the caller when positioned
within 50cm, 20" in front of the camera,
and will see in near darkness (1 Lux of
light).
TECHNICAL PRECAUTIONS
MY-CA has a camera angle presetting feature, programmable on inside video monitor. Refer to each Manual of MY-1CD, MY-2CD, etc.
Installation location: The MY-CA is weather resistant, but for best results it should be protected from direct weather conditions. An eave or overhead cover is
recommended to protect it from direct rainfall.
Temperature: The MY-CA is rated to operate at temperatures between -10°C ~ 60°C (14° and 140°F), When the outside temperature lowers rapidly, the
camera lens may fog up slightly, causing a blurry picture at the inside monitor. The ventilation openings will allow the moisture to evaporate, and
tho picture will return to normal.
Cleaning: Clean the unit with a soft cloth and neutral household cleanser. Do not use an abrasive cleaner or cloth.
8
SPECIFICATIONS
I Pan/tilt viewing area shown by dotted line
23cm (1T‘) upward
Power source
Camera unit
Scanning lines
image viewing area
Minimum illumination
Dimensions & weight
Camera is powered from monitor unit
CCD camera
525 lines
at 50 cm, 20" from camera
Vertical 90cm, 3'. Horizontal 180cm, 6'
(140cm, 47" in still position) when panned
and tilted fully
1 Lux at 50cm, 20" from camera
MY-CA
132mm high x 100mm wide x 47.5mm deep.
5-1/4” H
X 4” W X 2” D. Approx. 350g (0.77 ibs.)
This equipment has been tested and found to comply with the limits for a Class В digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inteference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• increase the separation between the equipment and receiver. • Consult the dealer or an experienced radioЯV technician for help.
WARRANTY
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of 2 years
after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective upon which examination
shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make the final decision whether there is a
detect in materials and/or workmanship; and whether or not the product is within the warranty.
This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in violation of
instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This warranty does not cover
batteries or damage caused by batteries used in connection with the product.
This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by Aiphone.
Aiphone will not be responsible for any costs incurred involving on site service calls.
•i*
-i-
Aiphone Co., Ltd. Nagoya, Japan
Aiphone Corporation, Bellevue, WA, USA
MY-CA-I(E) 0595F
-
2
-
@ COMMUNICATION SYSTEMS
AIPHONE
HOME, BUSINESS, INDUSTRY.
Printed in Japan (E)