Aiphone MY-CA - Manual

0595©
® AlPHONE
PanTilt Video Door Station
INSTALLATION & OPERATION MANUAL
SYSTEM OUTLINE & FEATURES----------------- ---------------
The MY-CA is a compact, surface mount pan and tilt video door station. It
can be used with any Aiphone MY video system (MY-1CD, MY-2CD, MY/IE,
MY/TD-H, MY/LEF).
PACKAGE CONTENTS
For 1 entry;
MY-1CD MY-CU
Connecting 1 At, 1A2
Terminals 1A1, 1A2
MYW-P1L
At, A2
For 2 or max. 3 entries;
MY-2CD MYW-P3CB MYW-P3L
i l l
1A1, 1A2
2A1,2A2
¡1
r:
ij
i
^ m, J!.
> PanTilt video door station (MY-CA)
>
Tamper-proof screwdriver
Packet of screws
Installation & Operation Manual
1A1, 1A2
2A1,2A2
3A1,3A2
I FEATURES
' Audio, video, and PanTilt control on 2 wires
' Pan and tilting of MY-CA camera
■ 100m, 330‘ to monitor on I.Ommo, 18AWG wire
’ Extended distance to 300 m, 980' with MYW-BA adaptor
(using 1.2mm0, 16AWG PE jacketed wire)
' Replace an existing doorbell and use the same wire
NAMES AND FUNCTIONS ------------
1A1, 1A2
2A1,2A2
3A1,3A2
LAYOUT EXAMPLE
iif.
I"!
l i \
MY-CA IT^
MY-1CD
Refer to the Installation & Operation manual packed with
main monitor or adaptor.
PanTilt MY-CA, when measured at 50 cm, 20" from the camera,
views an area of 51 cm, 20" vertically by 72 cm, 29" horizontally.
On any and every inside monitor, operate Pan/tilt control pad to
maximize viewing area, and Backlight button to view dimly lit or
strongly backlit areas.
INSTALLATION & WIRING--------------
I Wiring Use 2-conductor (parallel) cable. Coaxial cable
or 2 separate wires should not be used.
Parallel cable
(Extra wires)
c§
1 aii ^ a _
J
1 MY-1CD,
etc.
YES Installation
When existing chime wires are used, it is possible that the
wires may contain AC voltage current. Locate and remove
the bell transformer before actually connecting MY-CA.
Extra pair(s) in the installed cable can affect image quality,
and must be terminated with a 120 ohm resistor at each end
of wires at both MY-CA location and inside monitor(s).
-
1
-
MY-CA employs a CCD camera, and its perfor­
mance can be affected by bright direct light,
such as strong sunlight, gate light or street or
porch light which is directed into the camera
lens. Use backlight button to compensate for
silhouetted images.
Do not mount the MY-CA with a horizontal surface directly
below it (like a counter top), as feedback may occur
(microphone is looated on the bottom of unit.)