Before you install and operate the equipment, Actual terminal location, Installation – Aiphone DOOR STATION IC-DL1 User Manual
Page 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BEFORE YOU INSTALL AND OPERATE THE EQUIPMENT
— Prohibitions and precautions —
OPENER
* Operation;
1. 0nIC-D2, D3/DL2, DL3, DO NOT TOUCH CALL BUTTON OF OTHER ROOM. It will cut off present communicatio
and calls a corresponding room station.
2. Door release can be activated at non-communicating room stations also. Observe that door release is operated only when
receiving a call from door station.
* Installation;
1. DO NOT CONNECT ANY TERMINAL ON ANY UNIT TO AC POWER LINES.
2. When you mount IC-D/DL series door station in place of existing bell or chime, be sure to disconnect wires from the
present transformer.
3. Select the installation locations that would not be exposed to temperature/
humidity extremes, water, oil, dust, iron dust, inflammable & chemical products,
etc.
* Maintenance;
1. Clean your equipment with a soft cloth dampened with neutral household
cleanser.
2. Do not splash water on the door station by hose, etc.
3. Filling in directory and lamp replacement;
As shown; the transparent cover can be removed, using a supplied opener. Fill in
directory and slide the cover back to place.
To replace the lamp, turn off the system’s power supply and pull the lamp off
from the pin terminals, using a pincette, etc.
Be careful not to touch with other components.
PULL
ACTUAL TERMINAL LOCATION
; for connecting the first room station
: for connecting the second room station
; for connecting the third room station
I
+ [ , I —
I
: for power supply
NOTE; IC-D2/DL2 have no
IC-Dl/DLl have no
terminals.
nor |P3| [
es
] terminals.
3
IC-D3/IC-DL3 BACK VIEW
INSTALLATION
IC-D1 ~ 3 UNIT
MOUNTINGf
BRACKETS;
Connecting cable can be
passed from either top or
bottom of the chassis.
(*) Cut off the part by
nipper, etc. for cable
inlet.
* Surface-mounting to wall;
1. Remove a screw @ on bottom of IC-Dl ~ 3/IC-DLl ~ 3.
2. Attach the mounting bracket directly to wall with the supplied wood screws
screws.
3. After wiring, reattach IC-Dl ~ 3/IC-DLl ~ 3 unit to the mounting bracket.
_ 9 _
), or to one-gang box with the supplied