Aiphone IE-1AD(U) - Manual (Page 3)

(2) Wail-mounting installation;
IF-DA
IE-DC(
MAIN UNIT
SCREW
Surface mount
> .SINGLE­
GANG BOX
% -
83.5 mm
SCREW (2) BACK FRAME
lE-NC
MAIN UNIT
SCREW (2)
TERMINALS
Semi-flush mount
SINGLE­
GANG BOX
-'r
83.5 mm
(3-5/16")
'BRACKET
lE-JA
FRONT PANEL
MAIN UNIT
Flush-mount
.^2-GANG BOX
183.5 mm
(3-5/16")
r
TERMINALS
lE-FY WOOD SCREW (2)
Flush-mount
BACK BOX
*Master stations; Attach the mounting bracket to wall or single-gang box with the supplied wood screws or screw's. Insert the prongs o
the bracket into the holes of the body and pull the body downward. Be careful not to attach the bracket upside down.
* Door station; (*) When mounting to wall directly, remove the outlet part (*) on top or bottom of back frame to pass cable.
(**) Illustrates IF-DA's, and lE-DC mounts in the same manner.
a
WIRING DIAGRAIVI
2
(1) Bell transformer for both communication and door release; AC 12-16V, 450mA or more (when EL-9S is used).
AC 12-16V, 700mA or more (when door release of other manufacture is used).
(2) Door release; Use a door release EL-9S (AC 12V, 350mA) or other manufacture’s which does not exceed AC 12-16V
500mA, when powered by a system’s bell transformer.
(3) Locate a system’s power supply within a lOm/33’ distance from main room station, using 0.65 mm dia./22AWG wires.
SPECIFICATIONS
Power source; lE-lAD(U); Powered by a bell transformer AC 12-16V, 180mA OR a power supply DC 12-24V, 160mA.
Current consumption; Max. 180mA (AC 12-16V). Max. 160mA (DC 12-24V).
Calling; 4-stroke electronic chime (w/slide volume switch).
Wiring; 2 wires (to door station) (non-polarized)
2 wires (to door release) (must be separated from communication's cable).
Door release button contact capacity; DC/AC 24V, 0.5A.
Wiring distance; *Between lE-lAD(U) & door station;
AW G 24AW G 22AW G 20AW G 18AW G
Distance 300' 500' 750' 1,180’
Diarneter 0.5 mm 0.65 mm 0,8 mm 1.0 mm
Distance 90 m 150 m 230 m 360 rn
Dimensions; (H x W x D) 210 x 80 x 58 (mm); 8-1/4" x 3-1/8" x 2-5/16"
Weight; Approx. 450 g (1 lb.).
—
3
-