Audiovox MVX-470 - Manual (Page 18)

through fifth number in memory address 43 through 45
can be accessed sequentially in the same manner as
above.
END-TO-END SIGNALING
This feature permits you to utilize additional phone
services, such as accessing an alternate long distance
network, signaling a pager, or banking by phone etc,.
For these services the signaling should be in DTMF
(Touch Tone™).
SCRATCH-PAD DIALING
This feature permits you to enter a number to be redialed
(or store a number in memory) while engaged in a
conversation.
SCRATCH-PAD DIALING
WITHOUT KEYING
TONES
This feature permits you to activate scratch-pad memory
without annoying key tones over the circuit.
1 Press @, @), then enter a phone number.
“TONE OFF” will be displayed for 5 seconds.
(__ c «cc
The Microphone circuit will remain active, but the
tones will not be heard.
2. If necessary, press , then enter the
memory address to store the number.
3. To exit the Scratch-pad Mode, press (^, then key
(g) again.
“TONE ON” will be displayed for 5 seconds.
CALL TIME DISPLAY
This feature automatically records the elapsed time per
conversation. The talk time of the last call and
cumulative talk time can be displayed on the readout.
The timers can also be cleared if necessary.
To Display the Talk Time
1. Press (^, then key
2. While the key is held down, the cumulative talk time
will be displayed on the readout in minute format.
Example ... 18 min.
3. The talk time of the last call will be displayed on the
readout for 5 seconds after the (© is released.
While in a conversation, the talk time of a call in pro­
gress will be displayed. The display format is as fol­
lows.
Example
(U
1 min. and 25 sec.
n <
u (
Outgoing Call Timer Only
(Programmable Option)
Normal call timer operation is to time both the calls
made and the calls received, if the “outgoing call
timer only” function is activated (Programmable
Option), the call timer will only display the amount of
time when placing calls. It will not display the amount
of time for calls received.
To Clear the Timer
1. Press @, then enter the three-digit security code.
2. Press , key (i) then @).
“CLEARED” will be displayed for 5 seconds.
C L IR rE d
The timers will be cleared, and the count for the
cumulative talk time will start from zero.
tan£ an
34 35