Audiovox MVX-470 - Manual (Page 17)

The two emergency numbers must be pre­
programmed in the NAM memory (NAM:Number
Assignment Module).
Note: 911 is preset emergency number, (you may change
this number if you wish.)
Operation in Lock Mode
CKMiqiletTocansti
1. Enter (@)(©i©
"911" does not indicate, but the [LOCK]
indicator will light. (911 is emergency call
number)
2. Press
The [INUSEi indicator will
light.
LOCX
Tull Bull
NOTE: To terminate the call, press
(The INUSEl indicator will go out.)
One Touch Emergency Call
This feature permits you to place a call to an emergen­
cy number by a single key stroke, even when the unit is
in the “lock” mode. You can deactivate this feature to
prevent unintentional call by mistake.
1. Press key (© for more fhan 2 seconds. The first
emergency number that is pre-programmed in the
memory will be displayed, and I
IN USE! indicator will
light as a call is placed. The factory pre-set number
is 911.
2. If you wish to deactivate this feature, press the fol­
lowing key sequence.
| x | y |Z| 0©(g)(£)(XYZ is Security Code)
To activate this feature again, follow the same key
sequence.
When this mode is ON ,
OFF
E ~ C R L L
on
E ~ C R L i o F F
See also Programmable Emergency Call.
32
To Mute a Phone Conversation
P Example: To Mute a Phone Conversation -
1. Press 0,
nn» __
> on
Tull Biiil
2. The transmit audio will be muted and the
receive audio will be heard from the
receiver.
3. To return to normal
conversation.
Press 0, (© again.
flNMl
nn> <(
) (Ut
Tiill Bull
nnxLC -CC
» (UI.C
u<
r
4. Mute is reset when the call is terminated.
VOICE MAIL DIALING
This feature permits you to access, through telephone
lines, a computer system and send DTMF number
codes in sequence. Up to five numbers can be stored
and are sequentially accessed with one touch of the
Voice Mail Access” key. The first number is sent in
digital form to the cell site, then up to four other
numbers are sent with DTMF signaling.
To Store Numbers
Store the numbers to be linked into the special memory
address 41 through 45. Each number should be within
32 digits.
To Place a Call
Press @ “Voice Mail Access” key for approx.
O.Ssec. The first number in memory address 41 will
appear on the readout and will be sent digitally to the
cell site. After you hear the signal from the Operating
Office, press “Voice Mail Access” key again.
The second number is memory address 42 will appear
on the readout and is sent with DTMF tones. You will
monitor the tones through the loudspeaker. The third
33