Audiovox MVX-470 - Manual (Page 14)

Notes: 1. If the next letter or number is assigned on the
other key (not same key), you can display the
next letter or number without pressing (^.
2. You must enter the phone number first, then
apply the name. Entering a number after
applying the name will erase its name.
To Store Name with Phone Number
1. Enter the phone number.
2. Press to set Alpha Mode.
3. Enter the name you need. (Refer to “To Enter Names
using Alpha” .)
4. Press then enter the memory address (01
through 30), to store the number with the name into
memory.
Note: If you enter the phone number after enter­
ing the name, the name will be erased.
Example: To store the phone number -
' 1234597890 with thename
JACK into memory address 01
1. Enter the phone number;
(i„
2. Set Alpha Mode; (™^
3. Enter the Name;
(g)(g) (g)@(^(g)(g)
(J)(A) (C) (K)
!8345SnS3S
R iP H R
4. Store the Number;
To Recall from Memory with Name
Recalling from the repertory memory with name is iden­
tical to standard repertory recall."^When the number is
recalled, the display will show the Alpha Name Tag as
well as the stored phone number.
PLACING TELEPHONE
CALLS
To Place a Call
1. Enter the phone number.
2. The last 10 digits of the dialed number are dis­
played on the readout.
3. Press CsE^, The IN USE indicator will lights.
NOTE: If dialing error is made, press (^, then enter
the phone number again. Pressing @ momen­
tarily (Approximately less than 0.5 sec.) clears
the last digit only.
If the Call Fails to Go Through
• If you hearthe "reorder" signal, presscij^, then if there
were no dialing errors, press for redial. (Re­
dialing with digit keys is not necessary.)
• If the "intercept" signal is heard, pressCJ^then redial
the correct number.
Automatic Redial (Programmable
Option)
If the feature of Automatic Redial (Programmable
Option) is selected, your unit will automatically make sev­
en attempts to reach the cell site when the first try is not
successful.
The IN USE indicator will stay on, but the speaker will
be muted for thirty seconds. This is done so that you
do not hear the reorder signals out of the speaker. If
you need to terminate the automatic redial, press
'IST
26 27