Audiovox MVX-470 - Manual (Page 16)

3. The word “OFF” will appear in the display.
4. Enter your 4 digit PIN.
5. Press the key to turn your PIN feature on.
To turn the ANTI FRAUD feature on / off and change
PIN Number.
1. Enter your three digit security code.
2. Press the then @ 1 .
3. Your PIN number and the “ON/OFF” status will
appear in the display.
Note; See “To Recall a Number from Memory” and
“To Review the Prefix” for more details.
on or off
4. Press the (jJ) key to turn the PIN entry feature on or off.
5. If necessary, enter the new PIN Number.
6. After you have entered the desired on or off status
or new PIN Number, press the @ key then the @
key.
To place a call with the PIN entry feature in Voice Mail
dialing (See “VOICE MAIL DIALING” for more details)
1. Press the key for more than 0.5 seconds. The
last 10 digits of the number in memory address 41
will appear in the display. As your call is being pro­
cessed, the word “SEND PIN” will appear in the
display.
SEnd P
2. Press the @ key again, your call will then be sent
digitally to the cell site. After you hear the signal
from the Operating Office, press “Voice Mail
Access” key again. The second number in memo­
ry address 42 is sent with DTMF tones. You will
monitor the tones through the loudspeaker. The
third through fifth number in memory address 43
through 45 can be accessed sequentially in the
same manner as above.
To Place a Call with a Number in the
Memory
1. Press (^, then enter the yiemory address (01
through 30). The last 10 digits of the number will
appear on the readout. If the number is longer than 10
digits, press (^, then enter the first digit of the memo­
ry address, then hold down the second digit of the
memory address.
30
Press The IN_LI^ indicator will light as the
call is placed.
Example: To CALL the number 123-4S6--
7890 stored in the memory
number 07
1. Press I
2. Enter (
1234567890 is shown
on the display.
3. Press
lEB^SSnSSS
Tiill Bull
flNl^
'JOL/CCnOO:
iCDnoo tOJiJ
T.ill Bull
n
Speed Dialing
This feature permits you to place a call from the stored
memory locations without using the recall key.
Speed dialing is a quick method of placing calls from
memory.
1. Enter the one or two digits of memory address (1
through 9 and 10 through 30).
2. Press The last 10 digits of the phone number will
appear on the readout, and the ilNUSEi indicator will light.
Last Number Redial
This feature permits you to redial the last phone
number you attempted to call.
Numbers will be stored in memory only if key is
pressed.
1. Press then (£).
2. Press to send a displayed number.
Note: To clear the stored number, press (@ then
Programmable Emergency Call
(Programmable Option)
This feature permits you to place a call to two emergen­
cy numbers (maximum of 7 digits) even if your tele­
phone has been locked.
31