Front panel removal and installation, Air cleaning unit removal, Air cleaning unit installation – Amcor AOM 183HX User Manual
Page 12: The intake grille removal, The intake grille installation, The front panel removal, The front panel installation, Front panel removaland installation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FRONT PANEL REMOVAL AND INSTALLATION
AIR CLEANING UNIT REMOVAL
1. Open the intake grille ,and then remove the right air filter.
2. Pull the air cleaning unit grip in the direction of the arrow and
remove the unit.
AIR CLEANING UNIT INSTALLATION
1. Open the intake grille, and then insert the dust collection unit
into the indoor unit.
2. Install the right air filter, and then close the intake grille.
THE INTAKE GRILLE REMOVAL
1. Open the intake grille.
2. Pull down the knob.
3. Lift the intake grille upward, until the axle at the top of the intake
grille is removed .
THE INTAKE GRILLE INSTALLATION
1. The fixing axle of the intake grille is installed on the Panel.
2. Lay down the intake grille.
THE FRONT PANEL REMOVAL
1. Remove intake grille (Reference the intake grille removal.)
2. Remove four screws.
3. The thumb is hung on the lower part as shown in the figure ,
and it pulls to the front, pushing [ V ] mark,and bottom hooks (
two position)is removed from wall hook bracket.
4. The front panel bottom is pulled to the front, and bottom hooks
is removed indoor unit.
5. The front panel is pulled to the front, raising the upper surface,
and a front panel is removed.
THE FRONT PANEL INSTALLATION
1. Firstly, fit the lower part of the front panel,and insert top and
bottom hooks.(Three top sides, six bottom sides)
2. Four screws is attached.
3. The intake grille is attached.