Aiwa XR-M75 - Manual (Page 11)

NOTE
' When loading an 8 -cm ^3-inch^ disc, make sure to place it onto
the inner circle of the trav precisely. Otherwise, the disc may
be damaged or the disc compartment wiii not open. If it does
not open, piease consuit your Aiwa dealer for repair.
' Do not place more than one compact disc on one disc tray.
' Do not tilt the unit with discs ioaded. Doing so may cause
malfunctions.
’ When transporting the unit, remove the discs from the trays.
' When replacing the discs during play, do not replace discs other
than those facing you.
if you place a disc on the empty right inner tray, and then press
± OPIEN/CLOSE, “ERROR” is displayed and the disc
compartment may not close. Remove the disc on that tray.
PROGRAMMED PLAY
Never piace here.
RANDOM /REPEAT PLAY
Use the remote controi.
RANDOM play
All the tracks on the selected disc or all the discs can be played
randomly.
REPEAT play
A single disc or all the discs can be played repeatedly.
Press RANDOM/REPEAT while pressing SHIFT .
Each time it is pressed, the function can be selected cyclically.
RANDOM play — RANDOM lights up on the display.
REPEAT play — C+. lights up on the display.
RANDOM/REPEAT play — RANDOM and Cf. light up on the
display.
Cancel — RANDOM and disappear from the display.
To play all discs, press ► to start play.
To play a single disc, press one of DISC DIRECT PLAY 1-5 to
start play.
To select disc 4 or 5 from the remote control, press
DISC DIRECT
PLAY 4 or 5 while pressing SHIFT.
During random play it is not possible to skip to the previously
played track with
O
Up to 30 tracks can be programmed from any of the inserted
discs.
1
3
Use the remote control.
1 Press PRGM while pressing SHIFT in stop mode.
“PRG” is displayed .
5 c
2 Press one of DiSC DiRECT PLAY 1-5 to select a
disc.
To select disc 4 or 5, press DISC DIRECT PLAY 4 or 5 while
pressing SHIFT.
Go to the next step when the tray stops rotating.
3 Press numbered buttons 0-9 and +10 to program
a track.
Example:
To select the 25th track, press +10, +10 and 5.
To select the 10th track, press +10 and 0.
Selected track number Total number of selected tracks
6iV F-..01
Program number
IP 3^5 20
Total playing time of the
selected tracks
4 Repeat steps 2 and 3 to program other tracks.
5 Press ^ to start play.
To check the program
Each time ◄◄ or ►► is pressed in stop mode, a disc number,
track number, and program number will be displayed.
To clear the program
Press ■ CLEAR in stop mode.
To add tracks to the program
Repeat steps 2 and 3 in stop mode. The track will be programmed
after the last track.
To change the programmed tracks
Clear the program and repeat all the steps again.
To play the programmed tracks repeatedly
After programming the tracks, press RANDOM/REPEAT
repeatedly while pressing SHIFT until appears on the display.
NOTE
During programmed play, you can not use random play, check
the remaining time or select a disc or track. engli SH 1 0