AEG 4159 - Manual (Page 39)

According to the technical connection conditions of the eiectricity companies, a
fixed connection to the mains suppiy may oniy be made by an approved eiectri-
cai instailer.
Compiy with the VDE specifications when connecting the machine and aiso where
necessary with the additional reguiations of the iocal eiectricity companies. After
instaliation, iive parts and insuiated iines shouid not be accessibie with the test
finger to EN 60335/DIN VDE 0700.
Detaiis of the eiectricai connection are given on the rating piate. This is located
on the RH inside edge of the door, if the machine is convertible, the changeover
diagram directions given on the mains junction box must aiso be observed.
During appiiance connection, it is essentiai to ensure that the nominai voitage and
current type specified on the rating piate are the same as the mains voitage and
current type at the instaliation site. The necessary eiectricai fusing is also indi­
cated on the rating plate.
To disconnect the dishwasher from the mains supply, pull out the plug. Should
the appliance have a fixed wiring connection with the mains supply, it must be
disconnected by appropriate measures on the fixed wiring side (fuses, auto­
matic cutout, spurious current protection switch, or the like which have a
contact opening width > 3 mm).
Electrical connection
79