AEG 4159 - Manual (Page 34)

74
Installing your dishwasher
Your dishwasher must be installed stably and horizontally (align with a spirit level)
on a firm floor. The adjustable feet can be unscrewed with the spanner supplied
to equalise floor irregularities and to adjust the machine height to other pieces of
furniture.
If your dishwasher is instedled under a continuous worktop, please note the
following:
- The drain hose, supply hose, and mains lead must retain free mobility when run
inside the plinth cavity. This is to prevent the hoses and lead from being kinked
or squashed.
- When integrating build-under Appliances able to be fitted with a decorative trim
are being installed, it must be additionally ensured that the machine is firmly
screwed to the continuous worktop or to the adjacent furniture. It is imperative
to take this measure to guarantee the necessary tilt safety as per VDE specifi­
cations.
Depending on model, the dishwashers should be installed as follows:
Integrating machines (l-models)
To install, see the installation template supplied.
Important:
The appliance door can be lined with a vyood panel/furniture panel of the follow­
ing dimensions:
Width: .. 591 mm-594 mm
Thickness: 16 mm-24 mm ^
Height: depending on
- recess height
- plinth height
- matchup to the joint runs of adjacent furniture (e. g. drawer), though
max. 600 mm.
Important note! Should the furniture panel be longer than 600 mm, the appli­
ance door cannot be fully opened (the furniture panel bumps against the plinth).
In this case, the plinth must be cut out (see installation template) or overiength
door hinge kit BLT 60 used. You can obtain this under E-No. 911 239 008.
Build-under machines (U-models) and build-in machines (E-models)
To install, see the installation instructions supplied.
Free-standing machines can be installed free-standing without additional fixing.
Important note: (applies only to free-standing machines with original worktop)
If, for reasons of space, there is no alternative to installing your dishwasher directly
next to a gas or electric cooker or coal range, you must interpose a thermally
insulated, non-flammable panel (with a depth of 57.5 cm) between cooker and
dishwasher. This panel should be coated with aluminium foil on the side facing
the cooker.