AEG 4159 - Manual (Page 36)

Connection
Water supply
Your dishwasher has been built in accordance with the valid regulations govern­
ing water-consuming appliances and is equipped with safety devices which
prevent used water from flowing back into the cjrinking water mains. Your dish­
washer c:an be connected to either a cold or hot water supply of max. 60 “C.
Never ccnnecrt your dishwasher to open hot water appliances and continuous
flow heaters! '
The supply hose is fitted with a screwed hose connection (to DIN 259) and can
be connected to an outlet valve (water tap) w'lth male thread f^A").
Suitable washers are supplied with the machine. Do not use any washers other
than these!
The nut of the screwed hose connection can be tightened by hand. If you require
a supply hose which is longer than the one supplied, use only the VDE-approved
complete hose kit (obtainable from our service centre) continuously and to
adequate length.
Never lengthen existing hoses.
Important note! The supply hose must not be kinked, squashed, or twisted.
Please ensure careful running.
To avoid reductions in water supply to the kitchen, we recommend you to install
a separate tap. Failing this, fit a branch piece to the existing water tap.
Additional installation expenditure (on the building side) can be reduced by use
of conventional sink mixers with a connection and shutoff valve.
Minimum water pressure:
1 bar(10N/cm=, tOOkPa).
If your water pressure is under 1 bar, please ask our service centre for advice.
Maximum allowabie water pressure;
10 bar (100 N/cm®, 1 MPa).
For a water pressure over 10 bar, a pressure-reducing valve (obtainable from your
speciaiist retailer) must be fitted upstream.
S
c
76