Setting the rinse aid quantity to be dosed, Filling with detergent – AEG 4159 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

; ■ Ét ; i : ' j.i i ; ! ; i [■ t : . ; : !.!■ =

Setting the rinse aid quantity to be dosed

The dispensing unit is iocated inside the liiiing opening of the rinse aid dispenser.
You can use it to set the rinse aid quantity on a scaie of 1-6 corresponding to a

1-6 cm® rinse aid addition. The rinse aid dosage is factory-set to “4", At this

setting, there is sufficient rinse aid in the fuii dispenser for around 40 washing pro

grammes.

You shouid adjust the amount dispensed if you discover imperfect crockery re

sults (see the section on "if you think your dishwasher is not working properly").

□ To set the dose, open the dispenser by twisting the cap ’A revolution

anticiockwise (Rg. 6).

□ Set the dose seiector to the required position with a screwdriver.

Fig. 8

KLD1 (2)

□ Then ciose the cap again by twisting it clockwise.
□ Wipe off any spilt rinse aid^with a cioth.

Filling with detergent

Important)

Never use conventionai washing-up iiquids. The latter cause heavy

frothing, may even imply a loss of machine function, and the dishes will not be
cleaned. Use only branded dishwasher detergent for domestic dishwashers.
Always store the detergent in a dry place in a sealed container. Lumpy detergent
will not clean dishes.

Before starting a washing programme (except "Pre-wash"), you must fill the

detergent dispenser with dishwasher detergent powder. The detergent is auto

matically dispensed during the programme.