AEG 4159 - Manual (Page 25)

Setting the dishwashing programme
□ Close the door.
□ Fully turn on the water tap, If It Is off.
Important! If a washing programme has been started despite the water tap being
turhed off, switch off your machine, turn on the water tap, and reset the washing
programme.
Setting the dishwashing programme
□ Press the programme button for the programme you require {see “Programme
chart"). The display beside the pressed button appears red.
During the programme cycle, the programme cycle indicator cycles fonward,
indicating the status of the machine washing programme In each step. During
heating In the washing and rinse aid cycles, the programme switch remains
stationary unti! the necessary temperature is attained.
□ Turn the programme switch clockwise to position A or B as shown In the pro­
gramme chart.
n Press the ON/OFF button. The operating Indicator lights up. The programme
starts.
Programme correction
□ You can correct any washing programme you have Inadvertently set wrongly
by first switching off your machine with the ON/OFF button.
important! For reasons of radio interference suppression, you should operate
the programme switch only when your machine is switched off. Automatic
detergent addition could also be tripped.
□ Reset the washing programme you require,
interrupting the programme
□ A running washing programme is interrupted if you open the door.
□ Reclose the door. The washing programme restarts from the position where it
was interrupted.
□ You should open the door during the programme cycle only, when absolutely
necessary. When you reclose the appliance, the penetrating air is strongly
heated and expands. This may lead to programme cycle irregularities requiring
service centre attention.
65