AEG 4159 - Manual (Page 29)

Before calling our service centre, please check whether you can rectify the fauft
yourself by following the instructions given below. Should this.information be of
no assistance to you in a specific case, please contact our service centre.
□ The drain pump runs continuously - even when your machine is
switched off.
- The water protection system has responded. Firstturnoffthe water tap. Then
pull out the mains plug. If you have a fixed connection: switch off the fuse(s) or
unscrew the screw-in fuse(s). Call our service centre to determine the fault.
G The programme wiil not start.
- Are the fuses in the fixed wiring in order? Is your machine connected to the
electricity supply?
- Have you closed the door properly? Press the door shut.
G No water ffows in.
- Have you turned on the water tap?
-
is the strainer in the hose screw connection on the water tap choked? Clean
the strainer if necessary.
- Is the water supply hose kinked? Check hose running (seethe section on "Water
supply”).
G The programme cycie indicator sticks at the beginning of washing with
detergent
- Have you turned on the water tap?
-
Is the strainer in the hose screw connection on the water tap choked? Clean
the strainer if necessary.
- Is the minimum water pressure of 1 bar available? (see the section on "Water
supply”).
G The water is not pumped away.
- Is the drain hose kinked, squashed or twisted? Please ensure correct running.
(See section on “Water drainage”.)
- Is the sink trap obstructed? Check the sink trap.
G The crockery is not clean.
- Have you selected a programme that is suitable for the type and degree of
soiling of your crockery? (see "Programme chart”).
- Have you arranged the crockery so that the sprayed water has access to all
surfaces, both interns^ and external? The crockery baskets must not be over­
filled (see the section on “Arranging the crockeryi.
- Have the spray arms been qbstructed by crockery or cutlery? Please note that,
for better drainage of residual water at the programme end. the upper spray
arm obliquely tilts when it comes to rest. When operational, it automatically
runs in the horizontal position.
- Are all strainers on the floor of your dishwasher clean? Are the strainers
inserted properly (see the section on “Cleaning the strainers”).
- Have you used sufficient detergent? (see the section on “Filling with detergent”).
- Have you used branded detergent?
- Is the drain hose correctly run? (see the section on “Water drainage").