Bolens® 6hp tiller, Qty. main drive shaft input pinidn shaft, Gear assembly – Bolens 12203 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MODELS 12197 & 12203
BOLENS® 6HP TILLER
MAINE DRIVE SHAFT, INPUT PINION SHAFT & GEAR ASSEMBLIES
REF
No.
PART
No.
DESCRIPTION
QTY.
REF
No.
PART
No.
DESCRIPTION
QTY.
MAIN DRIVE SHAFT
INPUT PINIDN SHAFT
&
GEAR ASSEMBLY
1
1714
Bearing-tapered roller with race.. 1
6
9572
Screw-hex hd.,
2
20718
Gear-spur, main drive shaft...... 1
5/16-24x1-1/8*.......................
1
3
9301
Key-3/16 sq. X1........................ 1
7
9944
Washer-disc spring (concave
4
11603
Drive Shaft-main drive shaft is one-
surface faces pulley).............
1
piece with integral, single-lead
8
1108841
Key-3/16 sq.x 1-1/2..................
1
work-hardened worm at front to
9
20880
Pulley-transmission drive.........
1
drive the wheel worm gear, and
10
1440
Washer-support........................
1
integral six-lead work-hardened
11
85030
Oil Seal-input pinion shaft, front.
1
worm at rear to drive the tiller
12
9500
Ring-retaining (snap ring), externa 1
gear (also includes pressed-on
13
9953
Washer-thrust...........................
2
#1714 rear roller bearing, race
14
9428
Bushing.....................................
1
for bearing and #9301 key)... 1
15
9677
Set Screw-5/16-18x3/8*............
1
5
1224-1
Shim-rear bearing cap, .010 thick
16
20791
Input Pinion-steel shaft.............
1
(see Note 1 below)................ A/R
17
20792
Gear-input pinion......................
1
5
1224-2
Shim-same as above, but .030 thick
18
9093
Retainer-snap ring, external.....
1
(see Note 1).......................... A/R
19
20799
Pinion Assy-(incl. one each of Ref.
5
1224-3
Shim-same as above, but .005 thick
No.’s 16,17 and 18)...............
A/R
(see Note 1).......................... A/R
20
9517
Retainer-snap ring, internal......
1
1325C
Shim Set-includes the following
shims: two 1224-1; two 1224-2;
one #1224-3 ......................... A/R
NOTE 1-Shim between drive shaft rear bearing and rear bearing cap to achieve 5-to-10 thousandths of an inch (.005-.010) end
play on drive shaft.
A/R - As Required
* Specify GRADE 5 if ordering part locally.
15