Aiphone COLOR SENTRY KA-1MD - Manual (Page 8)

TECHNICAL PRECAUTIONS SPECIFICATIONS (KA-1MD)
operating temperature: KA-DA: -10°C ~ 60°C (14° ~ 140°F) .
KA-1MD: 0°C ~ 40°C (32°F ~ 104°F)
LCD monitor
It must be noted in advance that the TFT color LCD panel,
though manufactured with very high precision techniques,
inevitably has a very small portion of picture elements that are
steadily lit or not lit at all, which is not considered a unit
malfunction.
The LCD monitor looks dark in the bright sunlit area, etc.
Adjust BRIGHT control to high position to increase monitor
luminosity, or reduce ambient lighting.
• When holding handset close to video monitor, the image may
vary, but this is not a malfunction.
• KA-1MD unit surface becomes warmer while being powered,
but this is not a malfunction.
• Strong light, such as direct sunlight, etc. may cause silhouette
on the monitor, but this is not a malfunction.
• When outside temperature lowers sharply after rainfall, etc.,
the inside of camera may fog up slightly, causing a blurry
picture, but this is not a malfunction.
Normal operation will be restored when moisture evaporates.
• KA-1MD may collect dust on the top of the unit. Clean unit
as needed.
• Do not apply any caulking sealant around video door station.
The openings at the bottom will help rain to dissipate.
Cleaning
Clean KA-1 MD and KA-DA with a soft cloth dampened with
neutral household cleanser.
Never use any harsh cleaner or cloth. Do not spray high-
pressure water on KA-DA.
' Power source:
' Current consumption:
' Power supply:
' Call-in:
' Call-in image:
' Communication:
' Communication image:
' Camera:
• Image viewing area:
• Video-monitor:
• Key-mark button contact:
• Wiring:
' Wiring distance:
DC 24V.
700mA max. 45mA in standby
Use PS-24E or PS-24ME power
supply.
4-tone chime with adjustable
volume
30 sec. timed (approx.)
Handset, simultaneous
2-1/2 min. timed (approx.)
1/4 inch Color CCD w/DSP
(Digital Signal Processor)
76.5° Horiz., 58.5° Vert, at
50cm(20") in front of camera
79cm Horiz. x 56cm Vert.
(2'7"H
X 1'10'V).
4 inch TFT colored LCD
AC12V, 400mA.
2 parallel, non-twisted wires to
door, non-polarized
Diameter O.65mm0 1 .Omme 22AWG 18AWG
•KA-1MD ~ KA-DA 50m 100m 165' 330'
•KA-lMDtoMK-ISD/B 50m 75m 165' 245'
Dimensions:
H W D (mm) H W D
KA-DA 140 105 41 5-1/2" 4-1/8" 1-5/8"
KA-1MD 305 144 85.5 12" 5-11/16" 3-3/8"
• Weight:
KA-DA: 300g (0.66 lbs.) appox.
KA-1MD: 1.1 Kg.(2.43 lbs.) appox.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna. • Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. • Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radioATV technician for
help.
-j-
•i*
•I-
-I-
•f*
-»i» ^ •
WARRANTY
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of two years
after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective upon which examination
shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make the final decision whether there is a
defect in materials and/or workmanship; and whether or not the product is within the warranty.
This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in violation of
instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This warranty does not cover
batteries or damage caused by batteries used in connection with the product.
This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by Aiphone.
Aiphone will not be responsible for any costs incurred involving on site service calls.
♦ '•‘i* ♦
•i*
AIPHONE CO., LTD., NAGOYA, JAPAN
AIPHONE CORPORATION, BELLEVUE, WA, USA
AIPHONE EUROPE N.V., ANTWERP, BELGIUM
KAS-1ED-I/M(E) 0198A
COMMUNICATION SYSTEMS
AIPHONE
HOME, BUSINESS, INDUSTRY.
Printed in Japan (E)
-8-