Mounting, Ka-da, Ka-1md – Aiphone COLOR SENTRY KA-1MD User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MOUNTING-----------------------------------------------------------
KA-DA
1.
Pull the screw cover out and down at bottom.
2.
Loosen the tamperproof screw with the hexagonal wrench (provided).
3.
Mount back frame to 1 -gang box.
4.
Terminate wires, and mount KA-DA to back frame, aligning at top.
5.
Tighten the screw and replace the screw cover.
Opening the screw cover
KA-DA Bottom view
Surface wall mounting
KA-1MD
1.
Remove the mounting bracket attached on back of KA-1MD.
2.
Mount bracket on 1-gang box.
3.
Connect 2 non-polarized wires from KA-DA on back of KA-1 MD. (A1, A2)
4.
Connect 2 polarized wires from power supply. (+, —)
5.
Aligning at the marks, insert the prongs of bracket into KA-1 MD and slide down
until it properly locks.
6.
Suggested mounting height of the KA-1 MD is that the monitor portion is positioned at approximately
150cm(5’) above the floor.