Audiovox CTX-4200 - Manual (Page 16)

SYSTEM INHIBIT
(NAM OPTION)
This feature permits you to inhibit (by NAM Option)
cellular systems, or Roam Systems you do not want
to use, even when in that service area.
The |NO SV^ indicator flashes, if your A/B switch is
selected to any system that is inhibited.
MULTIPLE CITY
REGISTRATION
Some cellular users find it beneficial to register their
phone in multiple cities, rather than rely on “roam”.
The multiple city registration feature permits you to
reprogram from the handset, the different phone
numbers for the cities in which you are registered.
Each programmed phone number will be designated
as your home system.
The display format is as follows:
C 1 2 3
1 R 1 1 1 8 1 7 j S 6 0 3 0
b’i'tiss |CLR|, then enter the new system ID number (5
digits) followed by the corresponding phone number
(10 digits). Please include your area code.
You must register your unit with the carrier in order
to get both the system ID number and your phone
number.
Press |FUNC| then key . Your new phone number
will be displayed on the readout. (Holding down ,
to display your new system ID number.)
Note(l): System ID number and phone number can
not be programmed during a call.
Note(2): Calls are placed or received using only the
programmed phone number, in use at the
time of call.
RADIO FREQUENCY (RE)
CHANNEL INDICATOR
If necessary, you can see the RF channel number in
which your unit is operating.
1. Press |RCL| , key 1^ then [4] . The RF channel
number in which your unit is operating, RSSI and
SAT frequency will be displayed on the readout.
C123---RF channel Number
R187---RSSI value
S6030-SAT frequency
2. When on a call, the display will update when a
handoff occurs.
3. The display will remain on the readout until you
manually reset it by pressing any key.
15-SECOND PERSONAL
ANSWERING MESSAGE
With this feature you can record a short message for
callers.
When the phone receives a call in your absence, the
phone will answer it automatically with your pre­
recorded message which can be recorded for up to 15
seconds.
1. Voice Memory Mode
To Set Voice Memory Mode:
Press |CLR| to clear the readout, then press [L]
[~K] I fungi [#][§. ( [L] [K] is your unlock code.)
[MSGrg I will appear on the readout.
To Record a Message:
Lift the handset and press |STO|.
After a one second beep tone from the loudspeaker,
you can record your 15 second message in the unit
through the handset microphone. You will hear
two short beep tones 15 seconds after the first beep
tone, which tells you that recording time is up.
To Review Recorded Message:
Press |RCL| while the phone is in Voice Memory
Mode.
You will hear a one-second beep tone followed by
your recorded message either through the loud­
speaker (on-hook) or through the handset earpiece
(off-hook).
To Change Recorded Message:
Press [STO| while the phone is in Voice Memory
Mode.
After one second beep tone, the phone is ready to
record your new message.
30
31