Audiovox CTX-4200 - Manual (Page 15)

CALL TIME DISPLAY
This feature automatically records the elapsed time
per conversation. The talk time of the last call,
cumulative talk time, and the number of calls can be
displayed on the readout.
The timers can also be cleared if necessary.
With beep tones you can be notified of the approxi­
mate talk time (NAM Option) in approximately 60
second increments.
To Display the Talk Time of the Last Call
1, Press |RCL| , key ^ then [T] .
The talk time of the last call will be displayed on
the readout for 5 seconds.
While in a conversation, the talk time of a call in
progress will be displayed, and updated each sec­
ond, The display format is as follows.
|Q1m25i -I min, and 25 sec.
To Display the Cumulative Talk Time
1. Press [RCL| , key then .
The cumulative talk time will be displayed on the
readout in minute format for 5 seconds.
I 1 8m] "TSmin.
To Display the Number of Calls
1. Press 1RCL| , key then ,
The number of calls will be displayed on the
readout for 5 seconds. The display format is as
follows.
r 86c I ■■■Received or placed 86 calls
To Clear the Timer
1. Press |CLR| , then enter the three-digit security
code.
then [T]. 2. Press W to \ , key
The timers will be cleared, and the count for the
cumulative talk time and the number of calls will
start from zero.
One Minute Beep (NAM Option)
During conversation, you can be notified of the
approximate talk time by tones for the first five
minutes (a short monotone signal will sound every
minute and a double beep tone will be heard after
approximately 5 minutes.)
A/B SYSTEM SELECTION
This feature permits you to select the system you
need to use. The system that you are registered with
is the preferred system, and your home system.
1. Standard Mode
When you turn the unit on, the unit remembers the
last position of the A/B system selected, and will
start to scan the radio frequency channels of that
selection.
If you want to confirm the current mode, press
|FUNC| , key then [5 ■ Status indicator shows
the current mode. To return the unit to the stan-
dard mode, press fFUN^ , key then again.
Status indicator shows |ST^ . The unit will scan
the preferred system channels.
If unable to find an acceptable preferred channel,
the unit switches to scan the non-preferred chan­
nels.
2. Preferred System Only Mode
Press I FUNGI , key then |T] . Status indicator
shows [PRF| . The unit will scan the preferred
system only and prevents switching over to the
non-preferred system,
3. Non-preferred System Only Mode
Press [ fungi , key then . Status indicator
shows I N-PRF1 . The unit will scan the non­
preferred system only.
4. Home Only Mode
Press I FUNGI , key then . Status indicator
shows 1 Home |. You can place or receive calls only
within your home area.
Noted): The |ROAM[ indicator lights as follows.
Lights continuously;
When the unit is in the preferred system
in another city.
Flashes;
When the unit is in the non-preferred
system,
Note{2): The |NO SVC^ indicator flashes when the
unit is requesting service but not in the
requested service area.
28 29