Audiovox CTX-4200 - Manual (Page 14)

L i n k 1
1 1 1 7 1 4 1 6 3 4 7 9 =
7. After you received an answer from the long dis­
tance service office, press |SND| again. The DTMF
signal will be placed and the DTMF tone of your
ID number can be monitored through the
loudspeaker, | Link 2~1 will appear on the readout.
8, If your ID number is accepted, the long distance
service office will answer again, so press |SND| .
Then the long distance call will be placed and the
DTMF tone can be monitored through the
loudspeaker.
I Link"~^ will appear on the readout.
Note: The number linked in steps 1 through 5 can
also be stored in secret memory as stated in
the “Secret Memory”.
1. When a set of linked numbers which
includes a secret number has been stored in
memory address 91 through 99, enter the
three-digit security code, press
WcQ ,
memory address (91 through 99), and then
[SND| to place the call. | Link 1 1 will
appear on the readout, and the first linked
number will be called as shown in step 6
above.
If tbe secret number is not included in the
linked number, you need not enter the
three-digit security code in the above oper­
ation.
2. To complete the call, continue operations
as shown in steps 7 and 8.
SCRATCH-PAD DIALING
This feature permits you to enter a number to be
redialed (or store a number in memory ) while
engaged in a conversation.
SCRATCH-PAD DIALING
WITHOUT KEYING TONES
This feature permits you to activate scratch-pad
memory without annoying key tones over the circuit.
1. Press [ fungi , then key , then enter a phone
number. I Tone | will be displayed for 5 seconds.
The Microphone circuit will remain active, but
the tones will not be heard.
If necessary, press |STO|, then enter the memory
address.
To exit the Scratch-pad Mode, press [FUNC| ,then
key again or turn the unit off.
DATA TRANSMISSION
AUX I/O JACK on the phone cradle can be used for
a FAX machine, Modem or other Date Transmitting
equipment. Specifications of AUX I/O JACK are as
follows.
JACK : R J l l
Impedance : 600 ohms, Balance
Level
: Input nominal ~17dBV
; Output nominal —32dBV
Manual Mode
To set Data Transmission Mode
After a call is in progress (answered or sent), press
will appear on the FUNG , then SND Data
readout. Then the transmission and receiving audio
will be switched to the AUX I/O JACK.
To Exit Data Transmission Mode
Press I FUNGI , then |SND|, or terminate a call.
The indication | Data | on the readout will go out.
Automatic Mode
1. Before leaving the car, press I FUNGI, then key
(more than 1 second). The display shows I A.D/T |,
The unit will remain power-on even after the igni­
tion switch is turned off. If necessary, lock the unit.
2. When a call is received, the unit will automatically
make the connection, then the transmit and
receive audio will be switched to the AUX I/O
JACK.
3. This mode is automatically deactivated in the
following cases:
1) When the ignition switch is turned back to
“on” or “accessory” position.
2) When the safety timer is expired. (Refer to
“Safety Timer”.)
3) When I FUNG], then key are pressed again.
4) When one of the following features is activat­
ed.
• Calls in Absence Indicator
• 15-Second Personal Answering Message
26
27