American Dryer Corp. AD-400 - Manual (Page 10)

2. Three-Piece Shipment
The tumbler section is shipped separately from the base module, and the burner section is shipped as the
third piece.
Move the base module into position with a fork truck. Lift the tumbler section onto the base module by
cables through the lifting eye bolts on top of the tumbler section. There is a 1-inch bolt in each comer of
the base module. These must pass through the 1-1/8-inch diameter holes in each comer of the tumbler
section bottom so that the tumbler section sits flat on the four (4) base piston clevis blocks. Use the four
(4) sets of 1-inch nuts and washers provided to bolt the basket section to the base.
Make sure that the front of the tumbler section lines up with the front of the base module. The small gear
motor sits on the base module front. The sprinkler piping is on the left side of the tumbler section.
Bolt the bumer/heater section to the base module as per the instructions in the previous two-piece
shipment section.
3. Four-Piece Shipment
The tumbler section is shipped apart from the base module, and the burner section is broken down into
two separate pieces.
Apply a bead of silicone to the top flanges of the lower bumer/heater section. A tube of silicone is
included with the dryer. Lift the uppjer bumer/heater section onto the lower bumer/heater section by
cables through the lifting eye bolts on top of the upper bumer/heater section. Bolt these sections together
with the 5/16-18 hardware provided. Assemble the rest of the dryer using the information provided in
the previous sections.
4. Additional Reassembly
The pjendant arm now can be rebolted to the top of the burner section. Pass the 5/16-18 bolts through the
pendant arm tube and screw them into the weld nuts located on the top of the burner section.