Bolens 130-360A - Manual (Page 9)

NOTE
If the Recoil Starter Handle is not
locked after engine starts, putting
the rider into motion will stop the
engine.
PUTTING THE RIDER IN MOTION
1. Advance the Throttle Control from % to
FULL throttle to prevent strain on the engine
and to operate the cutting blade.
2. Depress the Clutch Pedal so the clutch lock
releases.
3. Depress the Brake Pedal so the brake lock
releases.
4. Place the Gear Shift Lever in the “FORWARD”
position.
5. Slowly release the Clutch Pedal.
6. To stop the rider, depress the clutch and
brake pedals.
7. The blade can be engaged either while moving
or while standing still. Move the Blade
Engagement Lever forward slowly until the
blade is running.
STOPPING
Engine— Turn the Ignition Key to the left to the
“OFF” position.
Rider— Depress the clutch and brake pedals.
Blade— Move the Blade Engagement Lever all the
way to the rear of unit.
IMPORTANT
After striking a foreign object, stop
the engine. Remove wire from spark
plug, thoroughly inspect the mower
for any damage, and repair the dam­
age before restarting and operating
the mower.
ADJUSTMENTS
1. The height adjustment for the cutting blade is
made by removing the front axle bolts and
moving the front wheels to one of the four cut­
ting positions. See figure 14.
2. The height adjustment on the rear wheels is
made by removing the bolt on the height ad­
justment on each side of the rear axle and
selecting one of the four positions. See figure
15.
\
WARNING
\
If any adjustments are made to the
engine while the engine is running
(e.g. carburetor), disengage all
clutches and blades. Keep clear of
all moving parts. Be careful of
heated surfaces and muffler.