Assembly, Tools required for assembly -see figure 1, Parts in carton and hardware pack -see figure 2 – Bolens 130-360A User Manual
Page 4: Caution, Tire pressure
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
B
ASSEMBLY
i :
TOOLS REQUIRED FOR ASSEMBLY
-See figure 1.
A (1)
V
2
"
Box or Open End Wrench
B (1) V4 " Flat Screwdriver
C (2) 7/16" Box or Open End Wrench
V
FIGURE 1.
^
K
D
X
FIGURE 2.
PARTS IN CARTON AND HARDWARE PACK
-See figure 2.
A (2) Truss Head Screws
V 4 - 2 0
x 5/8" Long
B (2) Truss Head Screws V4-20 x
V
2
"
Long
C (4) Hex Nuts
1
/
4-20
Thread
D (4) Lock Washers V4" I.D.
E (1) Steering Wheel
F (1) Steering Shaft Assembly
G (2) Tube Clamps
H (1) Steering Wheel Cap
I
(1) Hex Nut 5/16-18 Thread
J (1) Belleville Washer
K (1) Wave Washer
L (2) Hex Sems Bolts 5/16-18 x
3
/
4
" Long
M (4) Hex Bolts
1
/
4-20
X
5/8" Long
N (4) Hex Lock Nuts V4-20 Thread
■^NOTE
Reference to right-hand or left-hand
side of machine is from the driver’s
seat facing forward.
A
CAUTION
Do not use rear plastic cover to lift
unit.
TIRE PRESSURE
FOR SHIPPING PURPOSES, THE TIRES ON YOUR
UNIT MAY BE OVER-INFLATED. TIRE PRESSURE
SHOULD BE REDUCED BEFORE UNIT IS PUT IN
TO OPERATION. PRESSURE SHOULD BE AP
PROXIMATELY 15 P.S.I. EQUAL TIRE PRESSURE
SHOULD BE MAINTAINED. MAXIMUM TIRE
PRESSURE 30 P.S.I.
FIGURE 3.