Bolens 130-360A - Manual (Page 7)

7. Position the trailer hitch on the center of the
rear frame section and fasten with bolts A and
— nuts B. See figure 10.
8. Check ALL nuts and bolts for correct
tightness.
CONTROLS
The controls on your mower may be considered as
the Throttle Control, Recoil Starter Handle, Igni­
tion Key, Blade Engagement Lever, Brake Pedal,
Clutch Pedal and the Gear Shift Lever.
A. Throttle Control actuates the butterfly in the
carburetor and may be set at “CHOKE”,
“FAST” or “SLOW.” See figure 11.
'.J
.1
Blade Enqagement
i
'
Lever
NOTE
The clutch must be disengaged, the
blade must be disengaged and the
ignition key must be on before the
engine will start.
FIGURE 12.
FIGURE 11.
B. The Recoil Starter Handle is located on the left
hand side of the hood. To operate the Recoil
Starter Handle, twist it until it is in the horizon­
tal position and pull to start the engine. After
the engine starts, return the Recoil Starter
Handle to the mounting bracket and turn it to
the vertical position as shown in figure 12.
C. The Ignition Key must be turned to the right to
the “ON” position before the Recoil Starter
Handle is pulled to start the engine. Turn the
Ignition Key to the left to the “OFF” position to
stop the engine. See figures 12 and 13.
D. The Blade Engagement Lever engages and
disengages the blade. Pull the Blade Engage­
ment Lever back to stop the blade. Move the
Blade Engagement Lever forward to engage
the blade. See figure 11.