Bolens 130-360A User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

' 1

■ ■

>4*

Tiuss Scrpw Truss Screw

(B)

(A)

‘ I \

■ ■«; lb-

4. Assemble the hood with 5/8" truss screws (A)

to the rear of hood, and the

V z "

long truss

—screws (B) to the front of hood. Fasten with

lock washers (D) and hex nuts (C) to the in

side. See figure 7.

FIGURE 7.

Vi* ' >■

.* »■

5. Place wave washer (K), steering wheel (E),

— belleville washer (J), over end of steering shaft

and secure with hex nut (I), using a

V z "

wrench. See figures 8 and 9.

FIGURE 8.

Hex Nut (I)

Belleville

-w* Washer iJ>

Steering

Wheel (E)

NOTE

It may be necessary to reach inside

the hood and push up on steering
shaft to get the steering wheel on.

6. Place steering wheel cap (H) in position and

press by hand.

FIGURE 9.