Brake adjustment, Chain adjustment, Belt replacement – Bolens 130-360A User Manual
Page 11: Note, Transmission belt replacement, Warning, Figure 20. brake assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 18. LUBRICATION
FIGURE 19. LUBRICATION
BRAKE ADJUSTMENT
The brake adjustment is made by tightening the
hex nut on the brake band to compensate for
wear. Turn the hex nut one half turn and test the
brakes. Repeat until the brake is adjusted. See
figure 20.
Brake Drum
Brake Band
CHAIN ADJUSTMENT
The chain may require adjustment after a period of
use. Chain adjustment may also be necessary
when the height adjustment is changed. The chain
is adjusted as follows:
Step 1. Loosen elastic lock nuts on two rear ad
justment wheel hanger supports.
Step 2. Move rear axle assembly forward or back
ward as needed to make the proper
adjustment. •
Step 3. Tighten elastic lock nuts securely. See
figure 21.
FIGURE 21. CHAIN ADJUSTMENT
REAR WHEELS
A
CAUTION
Installation of tire to rim:
1. Lubricate tire beads and rim
flanges.
2. Do not exceed 30 P.S.I. when
seating beads.
3. Adjust to recommended pres
sure after beads are sealed.
BELT REPLACEMENT
NOTE
If there is gasoline in the gasoline
tank, place a piece of thin plastic
under the gas cap and tighten the
gas cap securely.
TRANSMISSION BELT REPLACEMENT
Step 1. Lift the front end of the rider up so it rests
on the rear wheels and seat.
\
WARNING {
FIGURE 20. BRAKE ASSEMBLY
Disconnect the spark plug wire and
ground it against the engine block.
11