Maintenance, I warning – Bolens 130-360A User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MAINTENANCE
CRANKCASE OIL
I WARNING {
Remove the spark plug lead before
performing any maintenance on the
machine.
a. Oil Check
Check the oil level in the crankcase before each
use of the machine and after every two hours of
operation. Keep the oil level to the overflowing
point. See figure 16.
FIGURE 16. OIL FILL
b. Oil Change
After the first two hours of operating a new
engine, drain the oii from the crankcase while the
engine is still hot and refill the crankcase with
new oil; thereafter, change the oil after every 25
hours of operation. This procedure ensures
minimum wear of engine parts and provides
virtuaily trouble-free operation. To change the oil,
proceed as follows:
Step 1. With the machine on level ground, place a
suitable metal container under the oil
drain plug located on the front of the
engine. See figure 17.
Step 2. After the oil has been drained completely
from the crankcase, replace the drain plug
and tighten.
Step 3. With the machine on level ground, remove
the oil filler plug. See figure 16. Fill the
crankcase until the oil overflows from the
oil fill hole. Fill slowly to avoid air locks.
The crankcase holds approximately 1%
pints of good quality SAE 30 type MS
engine oil. Replace the oil filler plug.
FIGURE 17. OIL DRAIN
LUBRICATION
a. Steering Gears.
Lubricate with multi-purpose
automotive type grease once a season.
b. Front Wheel Bearings.
Once a season, remove
the front axle bolts and coat the axle with a
multi-purpose automotive type grease and
reassemble. See figure 18.
c. King Pins.
Lubricate the king pins after every
25 hours of operation with SAE 30 oii. Wipe up
excessive oil with a rag. See figure 18.
d. Rear Axle Bearings.
Lubricate the rear axle
bearings after every 25 hours of operation with
SAE 30 oil. Wipe up excessive oil with a rag.
See figure 19.
e. Chain.
Remove the chain once each season,
clean in kerosene, dry and lubricate with a rag
saturated in SAE 30 oil. See figure 19.
f.
Transmission.
The transmission has been
lubricated at the factory and does not need to
be checked.
10