Audiovox MVX-850 - Manual (Page 18)

To Display the Cumulative Talk Time
1. Press 0 '¡^3.
The cumulative talk time will be displayed on
the readout in minute format for 10 seconds.
il8m: ...18 min.
To Clear the Timer
1. Press 0 'i©, then enter the three-digit
security code.
The timers will be cleared, and the count for
the cumulative talk time and the cumulative
outgoing call time will start from zero.
ITirmr Cleared! will be displayed on the readout
for 10 seconds.
One Minute Beep (NAM Option)
During conversation, you can be notified of the
approximate talk time by tones for the first five
minutes, (a short monotone signal will sound every
minute and a double beep tone will be heard after
approximately 5 minutes.)
SID MANAGEMENT
(NAM OPTION)
This feature enables you (by NAM option) to take
advantage of a family of SID groups. This is a
group of cellular systems in cities that your carrier
owns or has special billing arrangements with.
Your close family SID's (like brothers and sisters)
will be billed at the same rate as your home billing
and will be indicated as “Home” (i.e. both
are off) on your display. More distant
will be billed at a
and
family SID's (like cousins)
preferred rate. Your phone will display solid iBOAlMi
when using these groups of systems in their cities.
When flashing is displayed, you are using a
SID system that is not included in the NAM
assigned groups.
If yoUr display indicates flashing , you will
need to change your A/B switch selection or, please
refer to Multiple City Registration to change phone
registration to enable you to make a call.
If in question as to what SID (system identifica­
tion) you are using, push 0
’^^3 to display the
current SID.
A/B SYSTEM SELECTION
This feature permits you to select the system you
need to use. The system that you are registered
with is the preferred system, and your home sys­
tem.
When you turn the unit on, the unit remembers
the last position of the A/B system selected, and
will start to scan the radio frequency channels of
that selection.
1 .
2 .
3.
Press 0 iV).
The [A/B Switch] will appear on the readout.
The current mode will appear.
You can change the current mode by pressing
v'O or 0).
'43 : Scroll upward
43 : Scroll downward
• Standard Mode
The unit will scan the preferred system chan­
nels. If unable to find an acceptable pre­
ferred channel, the unit switches to scan the
non-preferred channels.
• Home Only Mode
You can place or receive calls only within
your home area.
• Preferred System Only Mode
The unit will scan the preferred system only
and prevents switching over to the non­
preferred system.
• Non-preferred System Only Mode
The unit will scan the non-preferred system
only._
Press 43.
The ISelectedl will appear on the readout.
34 35