Audiovox MVX-850 - Manual (Page 14)

To place a call with PIN entry feature in Voice
Mail Dialing.
1. Press the key for more than 0.5 seconds.
The last 10 digits of the number in memory
address 91 will appear in the display. As
your call is being processed, ISEND Plfl] will
appear in the display.
2. Press the key again, your call will then be
sent digitally to the cell site. After you hear
the signal from the Operating Office, press
“Voice Mail Access” key again. The second
number in memory address 92 is sent with
DTMF tones. You will monitor the tones
through the loudspeaker. The third through
fifth number in memory address 93 though
95 can be accessed sequentially in the same
manner as above.
To Place a Call with a Number in the
Memory
1, Press then enter the memory address (01
through 99). The last 10 digits of the number
will appear on the readout. If the number is
longer than 10 digits, hold down the second
digit of the memory address (after pressing @)
to see the prefix.
Note: See “To Recall a Number from Memory’
and “To Review the Prefix” for more details.
2. Press CsE^. The i^..:.D3E| indicator will light as
the call is placed.
Speed Dialing
This feature permits you to place a call from the
stored memory locations without using the recall
key. Speed dialing is a quick method of placing
calls from memory.
1. Enter the one or two digits of memory address
(1 through 9 and 10 through 99).
2. Press The last 10 digits of the phone
numbe^r will appear on the readout, and the
I1H..U8EI indicator will light.
Last Three Number Redial
This feature permits you to redial any of the last
three phone numbers you attempted to call.
Numbers will be stored in memory only if key
is pressed.
Note: If same telephone number is attempted more
than once phone will only utilize one memory
location.
1. Press The last phone number is
displayed on the readout.
Example:
[¡mnsiminiin
2. Press 0 or 0, the scrolled number is dis­
played on the readout.
0 : Scroll upward (with roll back to #1)
0 : Scroll downward (with roll up to #3)
3. Press 0^ to send a displayed number.
Note: Tq^ clear the stored number, press (0, then
three times.
Programmable Emergency Call
(NAM Option)
This feature permits you to place a call to 3
emergency numbers (maximum of 7 digits) even if
your telephone has been set to the locked, keypad
locked or restricted modes.
The three emergency numbers must be pre-pro­
grammed in the NAM,
Note: 911 is preset emergency number, (you may
change this number if you wish.)
Operation in Lock Mode or Keypad Lock Mode
1. Enter the emergency call number (911);
CD CD
(“911” does not indicate, but the or
will appear on the readout.)
2. Press the indicator will light^____
3. To terminate the call, press (The
indicator will go out.)
Operation in Call Restriction Mode
The operation and display are the same as in the
normal mode.
One Touch Emergency Call
This feature permits you to place a call to an
emergency number by a single key stroke, even
when the unit is in lock mode. You can deactivate
this feature to prevent unintentional call by mis­
take.
1. Press key D) for more than 2 seconds. The
first emergency number that is pre-programmed
in the NAM will be displayed, and
indicator will light as a call is placed. The
factory pre-set number is 911.
2. Press 0 Q.
The (1 k t f i d h w i l l appear on the
readout.