Audiovox MVX-850 - Manual (Page 17)

4. If your ID number is accepted, the long dis­
tance service office will answer again, so press
(SB^_
Then the long distance call will be placed and
the DTMF tone can be monitored through the
speaker.
3rd. Number will appear on the readout.
Pf^l^ 41516 t 7 l 8 l 9 i 0 l
Note; The number linked can also be stored in
secret memory as stated in the “Secret
Memory”.
1. When a set of linked numbers which
includes a secret number has been stored
in memory address 01 through 99, enter
the three-digit security code, press
memory address (01 through 99), and
then
to place the call. The first
linked number will be called as shown in
step 2 above.
If the secret number is not included in
the linked number, you need not enter
the three-digit security code in the above
operation.
2. To complete the call, continue opera­
tions as shown in the steps 3 and 4.
SCRATCH PAD DIALING
This feature permits you to enter a number to be
redialed (or store a number in memory) while
engaged in a conversation.
SCRATCH PAD DIALING
WITHOUT KEYING
TONES
This feature permits you to activate scratch-pad
memory without annoying key tones over the cir­
cuit.
1. Press Tone will appear on the readout.
The Microphone circuit will remain active, but
the tones will not be heard.
2. Enter the phone number.
If necessary, press @ then enter the
memory address.
3. To active the tones, press 0 again.
CALL TIME DISPLAY
This feature automatically records the elapsed time
per conversation. The talk time of the last call,
cumulative outgoing call time and cumulative talk
time can be displayed on the readout. The timers
can also be cleared if necessary.
With beep tones you can be notified of the approxi­
mate talk time (NAM Option) in approximately 60
seconds increments.
To Display the Talk Time of the Last Call
1. Press 0 (0 O-
The talk time of the last call will be displayed
on the readout for 10 seconds.
While in a conversation, the talk time of a call
in progress will be displayed, and updated each
second. The display format is as follows.
,,, 1 min. and 25 sec.
To Display the Outgoing Call Timer
Only
1. Press 0 (iB C0).
The outgoing call time will be displayed on the
readout for 10 seconds.
SS
r I ...12 min.
32
33