Sehing the clock, Setting the timer, Setting the clock setting the timer – Aiwa CX-NA31 User Manual

Page 20: Sehing the clock setting the timer, 0■ ^ \ / i

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SEHING THE CLOCK

SETTING THE TIMER

Press the CLOCK button while pressing the

SHIFT button on the remote control, and press
the

I I

SET button within 4 seconds.

v'' .'../.-r......

i :• ; i i i

i ! ! :

•si'.J LJ

Press the ◄◄ DOWN or ►► UP button to

designate the hour, and press the

I I

SET button.

The hour stops flashing and the minute starts flashing.

3 Press the ◄◄ DOWN or ►► UP button to

designate the minute, and press the

I I

SET

button.

The minute stops flashing on the display and the clock starts
from 00 seconds.

To display the current time

Press the CLOCK button while pressing the SHIFT button on

the remote control. The time is displayed for 4 seconds.

However, the time cannot be displayed during recording.

To switch to the 24-hour standard

Press the CLOCK button while pressing the SHIFT button on

the remote control and then press the ■ button within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

This is caused by a power interruption. The current time needs
to be reset.

If power is interrupted for more than approximately 24 hours,

all settings stored in memory after purchase need to be reset.

The unit can be turned on at a specified time every day with the
built-in timer.

Preparation

Make sure the clock is set correctly.

Use the remote control.

1 Press the TIMER button while pressing the SHIFT

button once to display ©, and press the

I I

SET

button within 4 seconds.

■ ^

\ /

If you press the

SET button after 4 seconds, another

operation may start.

Designate the hour of the timer-on time by

pressing the ◄◄ DOWN or ►► UP button, and
press the II SET button. Repeat to designate the
minute of the timer-on time.

After you designate the timer-on time, one of the source name
flashes on the display for 4 seconds.

3 Within 4 seconds, press the FUNCTiON button

repeatediy to seiect a source.

The selected source name flashes for 4 seconds.
• If this step is not completed within 4 seconds, repeat from

step 1.

• If the TUNER button is pressed, the band cannot be selected

fn this step.

4 Within 4 seconds, seiect the duration for the

timer-activated period with the ◄◄ DOWN or I

UP button.

■■■■’ f""i

TTTT' ^

■

:ij

ENGLISH