Basic recording, Inserting blank spaces, Rec/rec mute button to start – Aiwa CX-NA31 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BASIC RECORDING

This section expiains how to record from the tuner, CD piayer, or
externai equipment.

Preparation

• Use Type I (norrrtal) tapes oniy.
• Set the tape to the point where recording wiii start.
• Note that recording is done oniy one side of the tape.

INSERTING BLANK SPACES

4-second biank spaces can be inserted at the desired point during

recording. (Appiicabie when the source is TUNER or ViDEO/

AUX.)

;

1 Press the • REC/REC MUTE button during recording or

whiie in recording pause mode.

I:W»1 on the dispiay fiashes for 4 seconds and the tape runs

without recording. After 4 seconds, the deck enters the

recording pause mode.

‘

2 Press the

button to resume recording.

To insert a biank space of iess than 4 seconds,

press the •

REC/REC MUTE button again whiie l;i^H is fiashing.

To insert biank spaces of more than 4 seconds,

after the

deck enters recording pause mode, press the • REC/REC
MUTE button again. Each time the button is pressed, a 4-second
biank space is added.

1 Insert the tape to be recorded on into deck 2.

Insert the tape with the side to be recorded on first facing
out from the unit.

-REJECT

2 Press one of the function buttons and prepare

the source to be recorded.

To record from a CD,

press the CD button and ioad the

disc(s).

To record from a radio broadcast,

press the TUNER button

and tune in to a station.

To record from the connected source,

press the ViDEO/

AUX button and piay.

3 Press the

recording.

REC/REC MUTE button to start

/■ ■N

When the selected function is CD, playback and recording

Start

simultaneously.

To stop recording,

press the ■ button.

To pause recording,

press the

button. (Applicable when the

source is TUNER or VIDEO/AUX) To resume recording, press
again.

ENGLISH

To erase a recording

Make sure the microphone is not connected to this unit.
1 Insert the tape to be erased into deck 2 and press the TAPE/

DECK 1/2 button to display “TP 2”.

Set the tape to the point where the erasure is to be started.

3 Press the • REC/REC MUTE button to start the erasure.