Canon LV-S4 - Manual (Page 9)

9
Part Names and Functions
A built-in micro processor which controls this unit may occasionally
malfunction and need to be reset. This can be done by pressing the RESET
button with a pen, which will shut down and restart the unit. Do not use the
RESET function excessively.
Rear Terminal
w AUDIO IN (Stereo)
Connect the audio output from computer or video
equipment connected to q or y to this jack. (p15, 16)
t MONITOR OUT
This terminal outputs the signal coming from
COMPUTER / S-VIDEO / COMPONENT IN terminal.
(This terminal cannot output RGB(Scart) signal from
COMPUTER / S-VIDEO / COMPONENT IN terminal.)
(p15)
y COMPUTER / S-VIDEO / COMPONENT IN
Connect S-video output, RGB Scart 21-pin video output,
component video output or computer output to this
connector. (p15,16) e AUDIO OUT(VARIABLE)
Connect an external audio amplifier to this jack.
(p15, 16)
This terminal outputs sound from AUDIO IN terminal.
Pa
rt
Names and Functions
✽
q VIDEO
Connect the composite video output from video
equipment to VIDEO jack. (p16)
r SERVICE PORT
This jack is used to service this projector.
✔
Note:
• Audio out and Monitor out terminal works only when the projector is under operation and do not work when the projector is in stand-by state or Power
management mode (p41).
COMPUTER/ S-VIDEO/
COMPONENT IN
AUDIO IN VIDEO SERVICE PORT
RESET
AUDIO OUT
(VARIABLE)
MONITOR OUT
y t
r w e q