Canon LV-S4 - Manual (Page 18)

18
Basic Operation
Press the POWER button on the top control or on the
remote control unit, and a message "Power off?" appears on
the screen.
Press the POWER button again to turn off the projector. The
POWER indicator starts to blink red, and it continues while
the cooling fans are operating for about 90 seconds. (About
120 seconds when the fan mode is L2. See page 44.)
1
2
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU
TURN PROJECTOR ON, WAIT AT LEAST 5 MINUTES
BEFORE TURNING IT OFF.
DO NOT DISCONNECT AC POWER CORD WHILE
COOLING FANS ARE RUNNING OR BEFORE THE
POWER INDICATOR EMITS RED LIGHT. OTHERWISE
IT WILL RESULT IN SHORTENING THE LAMP LIFE.
3 When the projector has cooled down enough to be turned on
again, the POWER indicator emits red light. Then you can
disconnect the AC power cord.
The message disappears after 4 seconds.
✔
Note:
• The projector cannot be turned on during the cooling period with the POWER
indicator blinking red. You can turn it on again after the POWER indicator emits red
light.
• Do not operate the projector continuously without rest. Continuous use may result
in shortening the lamp life. Turn off the projector and give it a rest about an hour in
every 24 hours.
• This projector monitors internal temperature and automatically controls the
running speed of the cooling fans.
• If the WARNING indicator blinks or emits red light, see “Warning Indicator” on page
45.
Turning Off the Projector