Adding or modifying voice interfaces, Adding or modifying voice interfaces -17 – Cabletron Systems FRX6000 User Manual
Page 221
Configuring Voice Interfaces
12-17
SmartSwitch 1800 Voice Configuration
Peer Node Number
This parameter is not used if the peer node type is a SmartSwitch 1800. Enter a
number 1 to 61 to specify the node number of the remote device.
Peer Node Port
This parameter is not used if the peer node type is a SmartSwitch 1800. Enter a
number 1 to 17 to specify the voice port number on the remote device.
Local Node Number
This parameter is not used if the peer node type is a SmartSwitch 1800. Enter a
number 1 to 61 to specify the node number of the local SmartSwitch 1800. This
number must match the Voice Node Number entered in the system-level Voice
Parameters window (see
ConÞguring System-Level Voice Parameters
). The default value for this parameter is 1.
Local Node Port
This parameter is not used if the peer node is a SmartSwitch 1800. Enter a number
1 to 17 to specify the voice port number on the local SmartSwitch 1800.
Frame Relay RLP
Enter the RLP number of the logical interface of this end of the frame relay link.
This would always be 0 for RLP0 on the SmartSwitch 1800.
Frame Relay Port
Enter the port number of the local frame relay port over which Voice will be
transmitted. This will be port numbers 0 through 3 on the SmartSwitch 1800.
Frame Relay DLCI
Enter a number 16 to 991 specifying local frame relay DLCI over which Voice will
be transmitted.
Enable Fragment
This parameter is not currently supported and must be set to No.
Adding or Modifying Voice Interfaces
First, access the Voice Interface ConÞg Window (see
).
To add a new Voice Interface:
1.
Enter the configurable values for each interface.
2.
Click on
to add your new entry.
To modify an existing entry:
1.
In the list box, click to select the interface you wish to modify. The selected
entry will be highlighted. (Note that you can only modify one entry at a time.)