Cabletron Systems SPECTRUM FRX6000 - Manual (Page 206)

SmartSwitch 1800 Voice Configuration
12-2 Configuring System-Level Voice Parameters
Configuring System-Level Voice Parameters
Certain voice parameters apply to speciÞc voice ports or interfaces. Others are
system level, and apply to all voice calls on the node.
Using the Voice Parameters window, you can conÞgure the system-level voice
parameters. To access the window:
1. Click on to display the Device menu.
2. Drag down to Voice System Parameters, and release. The Voice Parameters
window,
Figure 12-1 , will appear.
Figure 12-1. Voice Parameters
You can conÞgure the following system-level voice parameters:
Voice Node Number
This number identiÞes the SmartSwitch 1800 as the source or destination node in
call setup frames. This number must be the Þrst four digits of each long-dial
number, and is the number that must be dialed to reach a remote device. If a
speed-dial number is conÞgured for the long-dial number, the operator can enter
that speed-dial number, and the Þrmware will read the long-dial number from the
speed-dial map table.
Country Code
This code is a telephone preÞx code that identiÞes the country in which the
SmartSwitch is installed. The following table contains a list of country codes.