Cabletron Systems SmartSwitch Router 9032578-02 - Manual (Page 23)

SmartSwitch Router User Reference Manual 23
Chapter 1: SmartSwitch Router Product Overview
To list the Enable commands, enter:
The Enable mode command prompt consists of the SSR name followed by the pound
sign(#):
To list the commands available in Enable mode, enter a question mark (?) as shown in the
following example:
List the Enable commands. ?
ssr#
ssr# ?
acl
- Show L3 Access Control List
aging - Show L2 and L3 Aging information
arp - Show or modify ARP entries
cli - Modify the command line interface behavior
configure - Enter Configuration Mode
copy - Copy configuration database
dvmrp - Show DVMRP related parameters
enable - Enable privileged user mode
exit - Exit current mode
file - File manipulation commands
filters - Show L2 security filters
http - Show http parameters
igmp - Show IGMP related parameters
interface - Show interface related parameters
ip - Show IP related parameters
ip-router - Show unicast IP Routing related parameters
ipx - Show IPX related parameters
l2-tables - Show L2 Tables information
logout - Log off the system
mtrace - Multicast Traceroute utility
multicast - Configure Multicast related parameters
ospf - Show/Monitor Open Shortest Path First Protocol
(OSPF).
ping - Ping utility
port - Show or change Port parameters
qos - Show Quality of Service parameters
reboot - Reboot the system
rip - Show/Query Routing Information Protocol(RIP)
tables
snmp - Show SNMP related parameters.
statistics - Show or clear SSR statistics
stp - Show STP status
system - Show system-wide parameters
tacacs - Show TACACS related parameters
traceroute - Traceroute utility
vlan - Show VLAN-related parameters