Cabletron Systems SmartSwitch Router 9032578-02 - Manual (Page 177)

SmartSwitch Router User Reference Manual 177
Chapter 10: Security Configuration Guide
Defining an IPX ACL
To define an IPX ACL, perform the following in the Configure mode:
Applying an ACL to an Interface
To apply an ACL to an interface, perform the following in the Configure mode:
Applying an ACL to a Service
To apply an ACL to a service, perform the following in the Configure mode:
Edit an ACL with the ACL Editor
To edit an ACL, perform the following in the Configure mode:
Monitoring Access Control Lists
The SSR provides display of ACL configurations contained in the system.
To display ACL information, enter the following command in Enable mode.
Define an IPX ACL. acl permit|deny ipx|ipxrip|ipxsap
Note: Additional fields depend on the protocol
type you select.
Apply ACL to an interface. acl apply interface
input|output [logging [on|off]]
Apply ACL to a service. acl apply service
[logging [on|off]]
Edit an ACL using the ACL Editor acl-edit
Show all ACLs. acl show all
Show a specific ACL. acl show aclname | all
Show an ACL on a specific interface. acl show interface
Show ACLs on all IP interfaces. acl show interface all-ip