Cabletron Systems SmartSwitch Router 9032578-02 - Manual (Page 183)

SmartSwitch Router User Reference Manual 183
Chapter 11: QoS Configuration Guide
Setting an IPX QoS Policy
To set a QoS policy on an IPX traffic flow, enter the following command in Configure
mode:
Specifying Precedence for an IPX QoS Policy
To specify the precedence for an IPX QoS policy, enter the following command in
Configure mode:
Configuring SSR Queueing Policy
The SSR queuing policy is set on a system-wide basis. The SSR default queuing policy is
strict priority. To change the queuing policy to weighted-fair queuing on the SSR, enter the
following command in Configure mode:
If you want to revert the SSR queuing policy from weighted-fair to strict priority (default),
enter the following command in Configure mode:
Allocating Bandwidth for a Weighted-Fair Queuing Policy
If you enable the weighted-fair queuing policy on the SSR, you can allocate bandwidth for
the queues on the SSR. To allocate bandwidth for each SSR queue, enter the following
command in Configure mode:
Set an IPX QoS policy. qos set ipx |any
|any |any |any
|any |any |any
Specify precedence for an
IPX QoS policy. qos precedence ipx [srcnet ]
[srcnode ] [srcport ]
[dstnet ] [dstnode ]
[dstport ] [intf ]
Set queuing policy to
weighted-fair qos set queuing-policy weighted-fair
Revert the SSR queuing
policy to strict priority. negate
set queuing-policy weighted-fair>
Allocate bandwidth for a
weighted-fair queuing policy. qos set weighted-fair control
high medium
low